![]() It's important to note that DHCP reservations are typically used for devices with static MAC addresses, such as desktop computers. Click "Add" and then "Close" to complete the reservation configuration.īy configuring the reservation, the DHCP server will always assign the specified IP address from the "Dev" scope to the desktop with the corresponding MAC address, regardless of the VLAN the desktop is connected to.Optionally, you can set additional DHCP options specific to the reservation, such as DNS servers, gateway, etc.Choose the "IP address" range from the "Dev" scope that you want to assign to the MAC address.Enter a "Reservation Name" (optional) and specify the MAC address of the desktop.Right-click on "Reservations" and select "New Reservation".Expand the server name, and then expand "IPv4".You can do this by opening the "Server Manager" > "Tools" > "DHCP". Access your Windows Server DHCP server.Identify the MAC address of the desktop that should receive an IP address from the "Dev" scope.Here are the general steps to configure a DHCP reservation on a Windows Server DHCP server: ![]() Since you mentioned using Juniper switches, it is recommended to configure the reservations on the DHCP server. The configuration of DHCP reservations is typically done on the DHCP server side rather than the switch side. In your case, you can create a reservation for the MAC address of the desktops that should receive an IP address from the "Dev" scope. DHCP reservations allow you to assign a specific IP address to a device based on its MAC address. ![]() ![]() ![]() To configure a specific MAC address to receive an IP address from a particular DHCP scope, you would need to implement DHCP reservations. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |